Sparkfun lepton3/2/2023 ![]() ![]() When inserting it into the breakout board be sure to use proper personal grounding, such as a grounding wrist strap, to prevent damage the module. The Radiometric Lepton module is extremely sensitive to electrostatic discharge (ESD). ![]() Note: This kit comes in two separate parts and will need to be assembled once received. FLIR LEPTON® Engineering Datasheet Information on this page is subject to change without notice. A few things to consider about this kit: the breakout board will accept a 3-5.5V input and regulate it to what the Lepton® wants, to read an image from the lepton module all you need is an SPI port, and to configure the camera settings you also need an I 2C port, although this is not required. Lepton 2.5: 500-0763-01 80 x 60 50° Yes Yes <8 -10 ☌ to +140 ☌ (-10 to 450 Typical) 17 m Lepton 3.0: 500-0726 -01 160 x 120 57° Yes <13 10 ☌ to +140 ☌ 12 m 3 3. GNSS-RTK Dead Reckoning Breakout to modu GPS wyposaony w ukad ZED-F9K firmy u-blox. Meanwhile, each breakout board in these kits provides the socket for the Lepton, on-board power supplies, 25Mhz reference clock (can be by-passed), power efficient 1.2v core voltage (can be by-passed), dual low noise LDO for 2.8V voltage (can be by-passed), 100 mil header for use in a breadboard or wiring to any host system. GNSS-RTK Dead Reckoning Breakout - modu GPS - ZED-F9K - Qwiic - SparkFun GPS-18719. The Lepton 2.5 can output a factory-calibrated temperature value for all 4800 pixels in a frame irrespective of the camera temperature with an accuracy of +/-5˚C. Was: MicroView - OLED Arduino Module - SparkFun DEV-12923 The MicroView is the first chip-sized Arduino compatible module that lets you see what your Arduino is. The PureThermal 3 FLIR Lepton Smart I/O Module is a hackable thermal. The Radiometric Lepton® LWIR module included in each Dev Kit acts as a sort of camera and packs a resolution of 80 × 60 active pixels into a camera body that is smaller than a dime and captures infrared radiation input in its nominal response wavelength band (from 8 to 14 microns) and outputs a uniform thermal image. PureThermal 3 - FLIR Lepton Smart I/O Board with Lepton FS 17 available DEV-20813. ![]() All you need to do to get this kit set up, simply attach the Lepton® imager module into the provided breakout, connect the headers, and you will be seeing in full darkness in no time! This kit includes a breakout as well as the Lepton® 2.5 longwave infrared (LWIR) imager. Do you see what we see? With the FLIR Radiometric Lepton® Dev Kit v2 you will be able to bring FLIR's thermal imaging reliability and power to your Arduino, Raspberry Pi, or any ARM based development tool all in an easy to access breadboard friendly package. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |